Getting Started With Device Management - Cisco CiscoWorks 1105 User Manual

Chapter 1 Getting Started
Note

Getting Started with Device Management

Table 1-2 Basic Initial Tasks
Task
1. Set up devices (access points, bridges,
routers, switches, and AAA servers).
2. Log into the WLSE using a Web browser. Enter the WLSE's IP address, followed by:1741; for
3. Enter device credentials.
4. Initiate discovery from the WLSE or
import devices from a file or from a
CiscoWorks2000 server.
5. Verify the discovery.
78-14947-01
Login sessions automatically time out after 30 minutes of inactivity.
Before you can use WLSE monitoring, configuration, firmware upgrading (or
downgrading), and reporting, you must set up your devices, initiate discovery, and
move devices into the managed state. To get started, follow the directions in the
Quick Start Guide for the CiscoWorks 1105 Wireless LAN Solution Engine or use
the following task list as a general guide.
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
Getting Started with Device Management
Description and References
See Set Up Devices, page 6-12
example, http://209.165.202.128:1741. Use the admin
username and the password you created during initial
setup of the WLSE.
Device community strings for all managed devices must
be entered on the WLSE. See
Credentials, page 6-6.
For access point configuration tasks, HTTP usernames
and passwords must be entered on the WLSE. See
Specify the HTTP Username and Password, page
If you are using discovery from the WLSE, add seed
devices and enable discovery. You can initiate an
immediate one-time discovery or schedule discovery for
a later time. See Managing Device Discovery, page
On the WLSE, verify that devices were discovered. See
Viewing Inventory and Discovery Task History,
page 6-27.
for details.
Specifying Device
6-9.
6-10.
1-7