Cisco CiscoWorks 1105 User Manual page 322

Using Discovery and Managing Devices
Table 6-5 Set Up Procedures for Routers and Switches (continued)
Task Procedure
3. (Optional) Set On IOS-based devices, enter configuration mode
the system name, and use the following commands.
contact, and
•
location
variables.
•
•
On Hybrid OS-based Catalyst switches, enter enable
mode and use the following commands:
•
•
•
Set Up AAA Servers
Step 1
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
6-16
To set the system name, use the hostname name
command.
To set the system contact, use the snmp contact
contact command.
To set the location, use the snmp location
location command.
To set the system name, use the set system
name name command.
To set the system contact, use the set system
contact contact command.
To set the location, use the set system location
location command.
The WLSE can monitor the performance of AAA (Authentication, Authorization,
and Accounting) services provided by CiscoSecure ACS Server. To enable
monitoring, you must:
• Configure CiscoSecure ACS server to recognize the WLSE as a client. Follow
the procedure in this section on each server.
• Configure the WLSE to add information about the LEAP, RADIUS, and
EAP-MD5 servers. For more information, see
Deleting AAA Servers, page
Procedure
Log into CiscoSecure ACS Server on a PC that will provide authentication
services to the wireless network.
Chapter 6 Performing Administrative Tasks
Notes
These variables make the
device more manageable.
The location variable
enables proper grouping of
devices into the
system-defined Location
group. For more information
about groups, see
Groups, page
The system name, system
contact, and location will
appear in the device detail
displays.
Adding, Modifying and
6-33.
Managing
6-37.
78-14947-01