Cisco CiscoWorks 1105 User Manual page 220

Managing Firmware Images
Note
To add the image to the Selected Images list, click Add.
Step 5
Repeat steps 4 and 5 to add more images.
Step 6
To remove an image from the Selected Images list, click Remove.
Step 7
Select the Overwrite Existing Images checkbox if you are importing an image
version that is already stored on the WLSE. Otherwise, the image import will fail
if the same version is already stored on the WLSE.
Click Import. An informational popup window appears. Do not close the popup
Step 8
window until you receive a message that either says the import was successful or
the import failed.
If the import is successful, a confirmation message appears and the image is saved
on the WLSE.
If the import fails, an error message appears. The import may fail for one of the
following reasons:
•
•
•
Step 9 For information on uploading firmware to access points and bridges, see
Managing Firmware Jobs, page
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
4-8
Images for Cisco Aironet 350 wireless bridges are listed in the Import
window as Cisco Aironet 350 access point images (that is, the names
begin with AP). To avoid confusion, you can rename these images after
importing them. For more information, see
WLSE, page 4-3.
The image you are trying to import is not valid. In that case, an error message
appears.
There is insufficient space on the WLSE to store images.
You specified an image that already exists in the image library and you did
not select the Overwrite Existing Image checkbox in Step 7.
Chapter 4
Editing Image Details on the
4-9.
Updating Device Firmware
78-14947-01