Cisco CiscoWorks 1105 User Manual page 380

Managing System Parameters
Table 6-10 System Parameters (continued)
Parameter
Aggregation Interval
Short Term Trending Inventory Truncation Interval
Aggregation Truncation Interval
Fault History Truncation Interval
Job History Truncation Interval
Step 2
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
6-74
To change a parameter's interval, select new values from the pulldown lists and
click Apply to save the changes. To reset the system parameter to their previous
values, click Reset.
Chapter 6 Performing Administrative Tasks
Description
Interval at which the performance data (from
Inventory Performance Attributes Polling
Interval) is aggregated. This is the data shown
in Report Trends.
For reports it is necessary to compute
Note
some attributes over longer periods
(average, percentages, changes). This
interval determines how often these
computations are performed.
Default: 3 hours
How long the performance data (from
Inventory Performance Attributes Polling
Interval) is retained by the WLSE.
Default: 1 day
How long the aggregated (historical) data is
retained by the WLSE.
Default: 15 days
How long the fault data is retained. This is the
data shown in Fault Description.
Default: 30 days
How long job data is retained. This is the data
shown in Configure > Jobs, Firmware >
Jobs, and Reports > Scheduled Email Jobs.
Recurring jobs are truncated every
Note
day to retain the last 30 runs.
Default: 30 days
78-14947-01