Cisco CiscoWorks 1105 User Manual page 86

Using the Templates
Enter the following information:
Step 3
Field
VLAN (802.1Q)
Tagging
Native VLAN ID
Single VLAN ID
which allows
unencrypted
packets
Optionally allow
Point-to-point
Packet Encryption
Using this option you can:
Step 4
•
•
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
3-32
Description
From the list, select one of the following:
Enabled—Use this setting to allow IEEE 802.1Q
•
protocol tagging on VLAN packets.
The IEEE 802.1Q protocol is used to interconnect
multiple switches and routers, and for defining
VLAN topologies.
• Disabled—Use this setting to not allow tagging.
Enter identification number of the access point's native
VLAN.
Note
Enter an identification number to allow unencrypted
packets. An entry with a value of 0 (zero) requires the use
of encryption.
From the list, select one of the following:
• Yes—Use this setting to allow point-to-point
encryption.
• No—Use this setting to not allow point-to-point
encryption.
Add a new VLAN—See
Delete an exiting VLAN from a Device—See
page 3-36.
This setting must agree with the native VLAN ID
setting on the switch.
Adding a New VLAN, page
Deleting an Existing VLAN,
Chapter 3 Configuring Devices
3-33.
78-14947-01