Cisco CiscoWorks 1105 User Manual page 67

Chapter 3 Configuring Devices
Field
Lookup MAC
address on
Authentication
Server if not in an
Existing Filter List?
Is MAC
Authentication alone
sufficient for a client
to be fully
authenticated?
New Destination
MAC Address
Allowed
Disallowed
Click Add to add the MAC address to the Current MAC Address Filters list.
Step 3
Step 4 To remove a MAC Address, select it from the Current MAC Address Filters list,
then click Remove.
78-14947-01
Description
Click one of the following:
• Yes—Use this setting to allow looking up a MAC
address on the authentication server.
No—Use this setting to disallow looking up a
•
MAC address.
From the list, select one of the following:
Yes—Use this setting to specify that client devices
•
that associate to the access point using 802.11
open authentication, first attempt MAC
authentication.
No—Use this setting to specify that MAC
•
authentication alone is not sufficient.
Click see details to see which versions this setting is
valid for.
Enter a destination MAC address by entering the
address in one of the following ways:
With colons separating the character pairs
•
(00:40:96:12:34:56, for example)
Without any intervening characters
•
(004096123456, for example)
Click to pass traffic to the MAC address.
Click to discard traffic to the MAC address.
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
Using the Templates
3-13