Options And Peripheral Equipment - Mitsubishi Electric MELSERVO-J4 Instruction Manual

9. OPTIONS AND PERIPHERAL EQUIPMENT

9. OPTIONS AND PERIPHERAL EQUIPMENT
WARNING
CAUTION
The following items are the same as MR-J4-_A_-RJ servo amplifiers. For details of the items, refer to each
chapter/section of the detailed explanation field. "MR-J4-_A_" means "MR-J4-_A_(-RJ) Servo Amplifier
Instruction Manual".
Before connecting any option or peripheral equipment, turn off the power and wait
for 15 minutes or more until the charge lamp turns off. Then, confirm that the
voltage between P+ and N- is safe with a voltage tester and others. Otherwise, an
electric shock may occur. In addition, when confirming whether the charge lamp is
off or not, always confirm it from the front of the servo amplifier.
Configure MR-HDP01 with sink interface.
Use the specified peripheral equipment and options to prevent a malfunction or a
fire.
Cable/connector sets
Regenerative option
FR-BU2- (H) brake unit
FR-RC-(H) power regeneration converter
FR-CV-(H) power regeneration common converter
Junction terminal block PS7DW-20V14B-F
(recommended)
MR Configurator2
Battery
Selection example of wires
Molded-case circuit breakers, fuses, magnetic contactors
(recommended)
Power factor improving DC reactor
Power factor improving AC reactor
Relay (recommended)
Noise reduction techniques
Earth-leakage current breaker
EMC filter (recommended)
External dynamic brake
Heat sink outside mounting attachment
(MR-J4ACN15K/MR-J3ACN)
Item
9 - 1
Detailed explanation
MR-J4-_A_ section 11.1
MR-J4-_A_ section 11.2
MR-J4-_A_ section 11.3
MR-J4-_A_ section 11.4
MR-J4-_A_ section 11.5
MR-J4-_A_ section 11.6
MR-J4-_A_ section 11.7
MR-J4-_A_ section 11.8
MR-J4-_A_ section 11.9
MR-J4-_A_ section 11.10
MR-J4-_A_ section 11.11
MR-J4-_A_ section 11.12
MR-J4-_A_ section 11.13
MR-J4-_A_ section 11.14
MR-J4-_A_ section 11.15
MR-J4-_A_ section 11.16
MR-J4-_A_ section 11.17
MR-J4-_A_ section 11.18