Options And Peripheral Equipment; Cable/Connector Sets - Mitsubishi Electric MR-J4 Instruction Manual

18. MR-J4-03A6 SERVO AMPLIFIER

18.8 Options and peripheral equipment

WARNING
CAUTION
The items in the following table are the same as those for MR-J4-_A_(-RJ) servo amplifiers of 100 W or
more. Refer to the section of the detailed explanation field for details.

18.8.1 Cable/connector sets

Purchase the cable and connector options indicated in this section.
Before connecting options and peripheral equipment, turn off the power and wait
until the charge lamp turns off. Otherwise, an electric shock may occur. In
addition, when confirming whether the charge lamp is off or not, always confirm it
from the front of the servo amplifier.
Use the specified peripheral equipment and options to prevent a malfunction or a
fire.
POINT
We recommend using HIV wires to wire the servo amplifiers, options, and
peripheral equipment. Therefore, the recommended wire sizes may differ from
those used for the previous servo amplifiers.
Junction terminal block MR-TB50
MR Configurator2
Battery
Relay (recommended)
Noise reduction techniques
POINT
The IP rating indicated for cables and connectors is their protection against
ingress of dust and raindrops when they are connected to a servo amplifier or
servo motor. If the IP rating of the cable, connector, servo amplifier and servo
motor vary, the overall IP rating depends on the lowest IP rating of all
components.
Item
18 - 79
Detailed explanation
Section 11.6
Section 11.7
Section 11.8
Section 11.13
Section 11.14