Mitsubishi Electric MELSERVO-J4 Instruction Manual page 331

7. PARAMETERS
No./ Setting
symbol/name digit
PT29 Set a polarity of DOG, SIG, PI1, PI2, and PI3.
*TOP3
_ _ _ x _ _ _ x (BIN): DOG (Proximity dog) polarity selection
Function
(HEX) 0: Dog detection with off
selection T-3
1: Dog detection with on
_ _ _ x (BIN): SIG (External limit/Rotation direction decision/Automatic speed
selection) polarity selection
0: Normally open contact
1: Normally closed contact
_ _ x _ (BIN): For manufacturer setting
_ x _ _ (BIN): For manufacturer setting
x _ _ _ (BIN): For manufacturer setting
_ _ x _ _ _ _ x (BIN): PI1 (Program input 1) polarity selection
(HEX) 0: Positive logic
1: Negative logic
_ _ x _ (BIN): PI2 (Program input 2) polarity selection
0: Positive logic
1: Negative logic
_ x _ _ (BIN): PI3 (Program input 3) polarity selection
0: Positive logic
1: Negative logic
x _ _ _ (BIN): For manufacturer setting
_ x _ _ For manufacturer setting
x _ _ _ For manufacturer setting
Convert the setting value into hexadecimal as follows.
0 0
Function
Setting
DOG (Proximity dog) polarity selection or SIG
(External limit/Rotation direction decision/
Automatic speed selection) polarity selection
Setting
PI1 (Program input 1) polarity selection
PI2 (Program input 2) polarity selection
PI3 (Program input 3) polarity selection
7 - 74
Initial
Control mode
value
CP CL PS
[unit]
0h
0h
0h
0h
Initial value
BIN HEX
0
0
0
0
0
Initial value
BIN HEX
0
0
0
0
0