Mitsubishi Electric MELSERVO-J4 Instruction Manual page 381

10. COMMUNICATION FUNCTION
(d) Deceleration time constant
Writes deceleration time constant of point tables.
Transmits the command [C] [8] + the data No. [0] [1] to [F] [F] corresponding to the point tables to
write. Refer to section 10.1.1.
When the deceleration time constant is changed frequently using communication, set "1" to the
mode to change only the RAM data in the servo amplifier.
When changing data once or more within an hour, do not write it to the EEP-ROM.
(e) Dwell
Writes dwell of point tables.
Transmits the command [C] [A] + the data No. [0] [1] to [F] [F] corresponding to the point tables to
write. Refer to section 10.1.1.
When the dwell is changed frequently using communication, set "1" to the mode to change only the
RAM data in the servo amplifier.
When changing data once or more within an hour, do not write it to the EEP-ROM.
Command Data No.
[C] [8] [0] [1] to [F] [F]
0
Hexadecimal
Writing mode
0: EEP-ROM/RAM writing
1: RAM writing
Command Data No.
[C] [A] [0] [1] to [F] [F]
0
Hexadecimal
Writing mode
0: EEP-ROM/RAM writing
1: RAM writing
10 - 30
Data
Refer to the following
diagram.
Data
Refer to the following
diagram.