Display Sequence - Mitsubishi Electric MELSERVO-J4 Instruction Manual

3. DISPLAY AND OPERATION SECTIONS

3.1 Display sequence

Press the "MODE" button once to shift to the next display mode. Refer to section 3.2 and later for the
description of the corresponding display mode.
Display mode transition
Status display
One-touch tuning
Diagnosis
Alarm
Point table setting
Basic setting
parameters
button
MODE
Gain/filter
parameters
Extension setting
parameters
I/O setting
parameters
Extension setting 2
parameters
Extension setting 3
parameters
Linear/DD motor
setting parameter
Option setting
parameters
Positioning setting
parameters
Initial screen
Servo status display.
For the point table and program,
is displayed at power-on.
For indexer,
(Note)
One-touch tuning
Select this when performing the one-touch
tuning.
Sequence display, drive recorder
enabled/disabled display, external I/O signal
display, output signal (DO) forced output, test
operation, software version display, VC
automatic offset, servo motor series ID
display, servo motor type ID display, servo
motor encoder ID display, teaching function
Current alarm display, alarm history display
and parameter error No./point table error No.
display
Display and setting of point table data.
The screen is displayed only in the point table
method, and is not displayed in other control
mode.
Display and setting of basic setting
parameters.
Display and setting of gain/filter parameters.
Display and setting of extension setting
parameters.
Display and setting of I/O setting parameters.
Display and setting of extension setting 2
parameters.
Display and setting of extension setting 3
parameters.
Display and setting of linear/DD motor setting
parameters.
Display and setting of option setting
parameters.
Display and setting of positioning control
parameters.
3 - 2
Function
will be displayed.
Reference
Section 3.2
MR-J4-_A_
(-RJ) Servo
Amplifier
Instruction
Manual
section 6.2
Section 3.3
Section 3.4
Section 3.5
Section 3.6
Section 3.7