Mitsubishi Electric MELSERVO-J4 Instruction Manual page 158

4. HOW TO USE THE POINT TABLE
(5) Verifying point table data (e)
Click the "Verify" button to verify all the data displayed and data of the servo amplifier.
(6) Detailed setting of point table data (f)
Click the "Detailed Setting" to change position data range and unit in the point table window. Refer to
section 4.7.2 for details.
(7) Single-step feed (g)
Click "Single-step Feed" to perform the single-step feed test operation. Refer to section 3.9 for details.
(8) Copy and paste of point table data (h)
Click "Copy" to copy the point table data. Click "Paste" to paste the copied point table data.
(9) Inserting point table data (i)
Click the "Insert" button to insert a block to the previous row from the selected point table No. The
selected point table No. and lower rows will be shifted down one by one.
(10) Deleting point table data (j)
Click the "Delete" button to delete all the data of the point table No. selected. The lower rows of the
selected point table No. will be shifted up one by one.
(11) Changing point table data (k)
Select any data to change and enter new value and click "Enter". You can change the displayed range
and unit with "(6) Detailed setting of point table data" of this section.
(12) Reading point table data (l)
Click "Open" to read the point table data.
(13) Saving point table data (m)
Click "Save As" to save the point table data.
(14) Updating project (n)
Click "Update Project" to update the point table data to a project.
4 - 71