Mitsubishi Electric MELSERVO-J4 Instruction Manual page 97

4. HOW TO USE THE POINT TABLE
(2) Point table
(a) Point table setting
Up to 255 point tables can be set. For using point table No. 16 to 255, enable DI4 (Point table No.
selection 5) to DI7 (Point table No. selection 8) in the device setting of MR Configurator2.
Set point tables using MR Configurator2 or the operation section of the servo amplifier.
The following table lists what to set. Refer to section 4.2.2 for details of the settings.
(b) Selection of point tables
Using the input signal or the communication function, select the point table No. with the
communication command from the controller such as a personal computer.
The following table lists the point table No. selected in response to the input signal and the
communication command.
However, when using the input signal to select the point table No., you can only use point table No. 1
to 15 in the initial status.
For using point table No. 16 to 255, enable DI4 (Point table No. selection 5) to DI7 (Point table No.
selection 8) in the device setting of MR Configurator2.
When using the communication function to select the point table No., refer to chapter 10.
DI7 DI6
0 0
0 0
0 0
0 0
0 0
1 1
1 1
Note. 0: Off
1: On
Item
Position data Set the position data for movement.
Servo motor
Set the command speed of the servo motor for execution of positioning.
speed
Acceleration
Set the acceleration time constant.
time constant
Deceleration
Set the deceleration time constant.
time constant
Dwell Set the waiting time when performing automatic continuous operation.
Sub function Set when performing automatic continuous operation.
Outputs the first digit and the second digit of the M code in 4-bit binary
M code
respectively.
Input signal (Note)
DI5 DI4 DI3
0 0
0 0
0 0
0 0
0 0
1 1
1 1
4 - 10
Main description
DI2 DI1
0 0 0
0 0 0
0 0 1
0 0 1
0 1 0
1 1 1
1 1 1
Selected point table
No.
DI0
0 (for home position
0
return)
1 1
0 2
1 3
0 4
0 254
1 255