Assembling The Cord End Terminal And The Power Cable - Huawei USG9500 Series Hardware Manual

HUAWEI USG9500 Series
Hardware Guide
Step 4 Crimp the joint parts of the bare crimping terminal and the conductor, as shown in
A-40.
Figure A-40 Crimping the joint parts of the bare crimping terminal and the conductor (JG
terminal)
Step 5 Slide the heat-shrink tubing (B) towards the connector until the tube covers the crimped part.
Then, heat the tube with a heat gun, as shown in
Figure A-41 Heating the heat-shrink tubing (JG terminal)
----End
A.2.2.3 Assembling the Cord End Terminal and the Power Cable
This section describes how to assemble a cord end terminal and a power cable.
Context
Figure A-42
labels in the following figure apply to all similar figures in this section.
Issue 03 (2017-12-15)
shows the components of a cord end terminal and a power cable. The component
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure A-41.
A Appendix
Figure
450