Huawei USG9500 Series Hardware Manual page 406

HUAWEI USG9500 Series
Hardware Guide
Step 6 Verify that the new power module is working normally.
After inserting the power module into the chassis, switch on the circuit breaker on the power
distribution cabinet and then switch on the power module. Then, you can verify if the new
power module is working properly in the following ways:
l
l
<sysname> display device
USG9520's Device status:
Slot #
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
1
2
3
4
5
6
7
8
9
10
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Issue 03 (2017-12-15)
power module along the guide rails horizontally until the power module properly
connects to the backplane. Fasten the captive screw with the Phillips screwdriver
and connect the power cable to the new power module.
Figure 3-40 Installing an EPW30B-48A power module on the USG9520
Check the RUN indicator on the panel of the power module. If it is green, the power
module is working normally.
Check the ALARM indicator on the panel of the power module. If it is yellow, a
recoverable fault has occurred on the power module.
Check the FAULT indicator on the panel of the power module. If it is red, an
unrecoverable fault has occurred on the power module.
Run the display device command on the console interface to check the running status of
the new power module. The power module is working normally if the following is
displayed:
Type Online
SPU Present
SPU Present
LPU Present
MPU Present
MPU Present
CLK Present
CLK Present
PWR Present
PWR Present
FAN Present
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Register Status
Registered Normal
Registered Normal
Registered Normal
NA Normal
Registered Normal
Registered Normal
Registered Normal
Registered Normal
Registered Normal
Registered Normal
3 Hardware Maintenance
Primary
NA
NA
NA
Master
Slave
Master
Slave
NA
NA
NA
394