Engineering Labels For Network Cables - Huawei USG9500 Series Hardware Manual

HUAWEI USG9500 Series
Hardware Guide
Label Example
Figure A-84
ODF.
Figure A-84 Example of the label on the optical fiber between the device and the ODF
ODF
The labels in
l
l
A.5.3 Engineering Labels for Network Cables
This section describes the applicable range and contents of the labels for network cables and
provides examples.
Applicable Ranges
The labels can be applied to Ethernet cables only.
Label Content
Table A-47
You can also fill in the labels according to the actual environment. If the device is not
installed in a cabinet, remove the cabinet number.
Table A-47 Information on the Ethernet cable labels
Content
MN-B-C-D
Issue 03 (2017-12-15)
shows an example of a label on an optical fiber that connects the device and the
G01 01 01 R
Figure A-84 are described as follows:
"ODF-G01-01-01-R" indicates that the local end of the optical fiber is connected with
the optical receiving terminal in row 01, column 01 of the ODF in row G, column 01 in
the machine room.
"A01-01-05-01-R" indicates that the opposite end of the optical fiber is connected with
optical receiving interface 1 on Slot 01, chassis 01 in the cabinet in row A, column 01 in
the machine room.
describes the content on both sides of the labels affixed to Ethernet cables.
Meaning
MN: cabinet
number
B: chassis
number
C: physical slot
number
D: network port
number
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Example
A01 is the first cabinet in row A.
Numbered from bottom to top with two digits, such
as 01.
Numbered from bottom to top and left to right with
two digits, such as 01.
Numbered top to bottom and left to right with two
digits, such as 01.
A Appendix
491