HUAWEI USG9500 Series
Hardware Guide
Figure A-2 RTN (+)
DC cable terminals vary based on the device. Two commonly used terminals are the OT bare
crimping terminal and the JG2 double-hole bare crimping terminal.
Bare crimping terminals must be crimped on both ends of the power cable.
Figure A-3
Figure A-3 OT bare crimping terminal
Figure A-4
Figure A-4 JG2 double-hole bare crimping terminal
If the power supply distance is longer than 35 m, you must place the DC power distribution
cabinet closer to the USG9500.
Prepare cables according to the distance between the USG9500and the power distribution
cabinet.
Issue 03 (2017-12-15)
shows the OT bare crimping terminal without a cable.
shows the JG2 double-hole bare crimping terminal without a cable.
NOTICE
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
A Appendix
417