Table of Contents
Advertisement
HUAWEI USG9500 Series
Hardware Guide
l
<sysname> display fan
Slotid
Present
Registered: YES
Status
FanSpeed
[1]40%
Slotid
Present
Registered: YES
Status
FanSpeed
[1]40%
Slotid
Present
Registered: YES
Status
FanSpeed
[1]40%
Slotid
Present
Registered: YES
Status
FanSpeed
[1]40%
The preceding command output indicates that the new fan module is normal. If the new fan
module is not working normally, contact Huawei technical personnel
----End
Follow-up Procedure
l
l
After replacing the fan module, collect all tools. If the replaced fan module is faulty, fill in the
Repair Transmission Sheet
to the equipment supplier or the specified repair service provider.
3.3.2 Replacing the Fan Module of the USG9560
This section describes the fan module of the USG9560 and the procedure for replacing the fan
module.
Precautions
l
l
l
Issue 03 (2017-12-15)
Run the display fan command on the console interface to view the running status of the
fan module. The fan module is working normally if the following is displayed:
: 27
: YES
: AUTO
: [No.]Speed
: 28
: YES
: AUTO
: [No.]Speed
: 29
: YES
: AUTO
: [No.]Speed
: 30
: YES
: AUTO
: [No.]Speed
Gather up and store the tools.
If a replaced fan module is confirmed to be faulty, fill in the Faulty Card for Repair and
send the faulty fan module and the card to the local Huawei office for repair.
When removing an old fan module, first pull it out about 5 cm, then stop. After the fans
stop rotating, continue pulling out the module.
The USG9560 has two fan modules. You can replace only one fan at a time.
The fan modules of the USG9560 are located at the rear of the chassis.
shows a fan module.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
and send the faulty module with the Repair Transmission Sheet
3 Hardware Maintenance
Figure 3-20
376
Advertisement
Table of Contents
