Huawei USG9500 Series Hardware Manual page 351

HUAWEI USG9500 Series
Hardware Guide
2.
3.
Step 12 Insert the new MPU/SRU into the chassis.
1.
2.
Issue 03 (2017-12-15)
Figure 3-2 Removing CF card 1
1
Put CF card 1 removed from the new MPU into the electrostatic discharge (ESD) bag.
Insert CF card 1 removed from the to-be-replaced MPU to the CF card 1 slot of the new
MPU and press the CF card as shown in (1) in
Figure 3-3 Inserting CF card 1
1
Support the lower edge of the new MPU/SRU with one hand and hold the panel with the
other hand. Then, insert the new MPU/SRU smoothly into the chassis along the guide
rail of the slot. Stop sliding the MPU/SRU forward when the ejector levers on the front
panel of the MPU/SRU reach the chassis, as shown in
Turn the ejector levers on the MPU/SRU outward and upward to form a 45-degree angle,
and at the same time push the MPU/SRU into the slot. Then, turn the ejector levers
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2
Figure
3 Hardware Maintenance
3-3.
Figure 3-4 (1).
339