Huawei USG9500 Series Hardware Manual page 470

HUAWEI USG9500 Series
Hardware Guide
Step 8 Attack the connector body to the wire holder and turn the metal shell 90°, as shown in
A-56.
Figure A-56 Attaching the connector body to the wire holder
Step 9 Slide the metal shell towards the connector body until the wire holder and the connector body
are wrapped completely. Crimp the connector, as shown in
Figure A-57 Crimping the connector
Step 10 Slide the jacket towards the metal shell until the metal shell is wrapped. One end of the cable
is now completely assembled, as shown in
Figure A-58 Wrapping the metal shell
Issue 03 (2017-12-15)
NOTE
Ensure that the wire holder is in sufficient contact with the connector body.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure
Figure A-58.
A Appendix
Figure
A-57.
458