Huawei USG9500 Series Hardware Manual page 466

HUAWEI USG9500 Series
Hardware Guide
Figure A-46 Shielded RJ45 connector
A. Connector jacket
E. Ethernet cable jacket F. Shield layer of Ethernet cable
Procedure
Step 1 Fit the connector jacket onto the Ethernet cable, as shown in
Figure A-47 Fitting the jacket of the connector onto the Ethernet cable
Step 2 Remove a 30-mm long section of the jacket, cut off the nylon twine inside the jacket, and cut
a 5-mm cleft in the cable jacket, as shown
l When removing a section of the jacket, be careful not to damage the shield layer of the
l When removing the shielding layer, be careful not to damage the insulation layer of the
Issue 03 (2017-12-15)
B. Metal shell of connector
NOTICE
twisted-pair cable.
twisted-pair cable.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
C. Connector wire holder
G. Twisted-pair cable
Figure
Figure A-48.
A Appendix
D. Connector plug
-
A-47.
454