Huawei USG9500 Series Hardware Manual page 426

HUAWEI USG9500 Series
Hardware Guide
Figure 3-56 Labeling a new optical cable
Step 8 Lay out the new optical cable neatly in the cabinet and bind the cable with a binding strap.
The optical cable must be bound with adequate tightness and leaving enough space. Bind any
extra cable to the ODF side.
Step 9 Check whether the new optical cable is working normally.
l
l
l
----End
Follow-up Procedure
l
l
Issue 03 (2017-12-15)
Check the LINK indicator at the optical interface. If the indicator is steady green, the
link is Up.
Check whether the service on the board where the new optical cable connects is normal.
If services are normal, the optical cable is replaced successfully.
Check whether there is any new alarm or performance event.
Gather up and store the tools and old optical cable.
Separate the old and the optical cables to avoid confusion.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Hardware Maintenance
414