Table of Contents
Advertisement
HUAWEI USG9500 Series
Hardware Guide
Before connecting a cable, ensure that the port is labeled and that the cable is inserted into the
correct port. Otherwise, the port module or the device may be damaged.
Before bundling network cables, use a network cable tester to test cable connectivity. Bind the
network cables to form a rectangle inside the cabinet. Each bundle contains a maximum of 20
network cables. Ensure that the cable ties are tidy and tied in the same direction.
The distance between the power cable, PGND cable, and signal cable must be greater than 30
mm.
Procedure
Step 1 If multiple network cables need to be connected, attach temporary labels to both ends of each
cable.
Step 2 Remove the dust-proof caps from a board interface and insert the electrical module into the
interface.
Step 3 Connect one end of a network cable to the electrical transceiver of the USG9520 and the other
end to the Ethernet port of the peer device based on the network plan.
Figure 2-59 Connecting a network cable
Issue 03 (2017-12-15)
NOTICE
NOTE
The electrical module can be inserted only in odd-numbered interfaces on the 24-port 100/1000Base-X-
SFP flexible interface card.
E8KE-X-101-24XGE-SFP
LINK
RESET
MGMT-ETH
E8KE-X-101-24XGE-SFP
Ethernet cable
1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
LINK
RESET
ACT
ALM
RUN
OFL
E8KE-X-101-24XGE-SFP
2
2 Hardware Installation
Ethernet interface
of the peer device
311
Advertisement
Table of Contents
