Table of Contents
Advertisement
HUAWEI USG9500 Series
Hardware Guide
Figure A-20 OT bare crimp terminal
Installation
1.
2.
3.
4.
The OT terminal may rotate, causing damage to the device. Ensure that the OT terminal is not
touching adjacent metal mechanical parts and other terminals.
Technical Specifications
Table A-15
Issue 03 (2017-12-15)
Connect the OT bare crimp terminal at one end of the PGND cable to the connection
hole of the USG9500, with the conducting wire upward, as shown in
Figure A-21 Installing the OT bare crimp terminal
A
Select a matching screw for the screw jack and screw it in clockwise. For a reliable
connection, make sure that at least two full threads match each other.
Tug on the power cable gently to verify that it is connected securely.
Connect the other end of the PGND cable to the ground port of the equipment room or
cabinet.
NOTICE
shows the technical specifications of the PGND cable.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
B
A Appendix
Figure A-21
(A).
432
Advertisement
Table of Contents
