Huawei USG9500 Series Hardware Manual page 461

HUAWEI USG9500 Series
Hardware Guide
l When you strip a power cable, be careful not to damage the cable conductor.
l If the bare crimping terminal is not from Huawei, adjust the value of L as required.
Figure A-38 Stripping a power cable (JG terminal)
Table A-25 Mapping between the cross-sectional area of the conductor and the value of L
Cross-Sectional Area of Conductor
(mm
16
25
35
50
Step 2 Slide the heat-shrink tubing (B) onto the bare crimping terminal, as shown in
Figure A-39 Sliding the heat-shrink tubing onto the bare crimping terminal
Step 3 Attach the bare crimping terminal (A) to the exposed conductor, and ensure that the bare
crimping terminal is in sufficient contact with the insulation layer of the power cable, as
shown in
Issue 03 (2017-12-15)
NOTICE
2
)
Figure A-39.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Value of L (mm)
13
14
16
16
A Appendix
Figure A-39.
449