Huawei USG9500 Series Hardware Manual page 464

HUAWEI USG9500 Series
Hardware Guide
Cross-
Sectional
Area of
Conductor
(mm
2.5
4
6
Step 2 Attach the cord end terminal (A) to the conductor, and ensure that the conductor is aligned
with the edge of the cord end terminal, as shown in
After the conductor is fed into the cord end terminal, ensure that the protruding length of
conductor does not exceed 1mm.
Figure A-44 Attaching the cord end terminal to the conductor
Step 3 Crimp the joint parts of the cord end terminal and the conductor, as shown in
Figure A-45 Crimping the cord end terminal and the conductor
Step 4 Check the maximum width of the tubular crimped terminal. Maximum widths are listed in
Table
Issue 03 (2017-12-15)
Value of L1 (mm)
2
)
10
12
14
NOTICE
A-27.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Cross-Sectional
Area of Conductor
2
(mm )
25
35
50
Figure A-44.
A Appendix
Value of L1 (mm)
18
19
26
Figure A-45.
452