Table of Contents
Advertisement
HUAWEI USG9500 Series
Hardware Guide
Procedure
Step 1 Feed both cable connectors into the ports of the cable tester.
Step 2 After the connectors are properly inserted, turn on the tester. If the indicators from 1 to G turn
on simultaneously, the pins are working normally and the wires are correctly connected.
Figure A-70 Testing wire connection and conduction
Step 3 Hold the connectors shown in
whether the metal contact strips are in sufficient contact with the core wires and Ethernet
ports.
Figure A-71 Checking connection reliability
Issue 03 (2017-12-15)
NOTE
Turn the switch to the S position and check whether the indicators turn on simultaneously.
shows a test with both indicators on.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure A-71
and gently shake it. Then repeat
A Appendix
Figure A-70
Step 2
to check
465
Advertisement
Table of Contents
