Huawei USG9500 Series Hardware Manual page 384

HUAWEI USG9500 Series
Hardware Guide
2.
3.
Step 6 Check the running status of the inserted SPC.
1.
2.
Issue 03 (2017-12-15)
Holding the captive screws of the SPC, insert the SPC smoothly along the guide rails of
the slot until the SPC is fully inserted into the slot, as shown in
Using the Phillips screwdriver, turn the two captive screws clockwise to tighten them, as
shown in Figure 3-16 (2).
Figure 3-16 Inserting an SPC into the SPU
Run the display device command on the standby FW to query the running status of the
SPU motherboard. The SPU motherboard is running properly if all items on the SPU
motherboard in the corresponding slot are displayed as follows:
HRP_S<sysname> display device
USG9520's Device status:
Slot # Type
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
1 SPU
2 SPU
3 LPU
4 MPU
6 CLK
8 PWR
9 PWR
10 FAN
Run the display device pic-status command on the standby FW to query the operating
status of the subcard. The subcard is running properly if all items on the corresponding
subcard are displayed as follows:
HRP_S<sysname> display device pic-status
Pic-status information in Chassis
1:
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
-
SLOT PIC Status Type
down Registered Cpu
1 0 Registered SPU_CARD_TYPE_IPS
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1
Online Register
Present Registered
Present Registered
Present Registered
Present NA
Present Registered
Present Registered
Present Registered
Present Registered
3 Hardware Maintenance
Figure 3-16
Status Primary
Normal NA
Normal NA
Normal NA
Normal Master
Normal Master
Normal NA
Abnormal NA
Normal NA
Port_count Init_result
0 SUCCESS
(1).
2
Logic
372