Table of Contents
Advertisement
HUAWEI USG9500 Series
Hardware Guide
3.
4.
Step 5 Insert a new SPC into the SPU.
1.
2.
3.
Issue 03 (2017-12-15)
Holding the captive screws of the SPC, pull out the SPC, as shown in
NOTICE
– Pull out the SPC slowly and smoothly so that it does not bump into neighboring
boards and cause a malfunction.
– When removing an SPC, do not touch the parts on it to avoid damaging the SPC.
Figure 3-13 Pulling out an SPC from an SPU
Place the removed SPC into the ESD bag.
Take out the new SPC from the ESD bag.
NOTICE
– Pull out the SPC slowly and smoothly so that it does not bump into neighboring
boards and cause a malfunction.
– When removing an SPC, do not touch the parts on it to avoid damaging the SPC.
Holding the captive screws of the SPC, insert the SPC smoothly along the guide rails of
the slot until the SPC is full inserted, as shown in
Using the Phillips screwdriver, turn the two captive screws clockwise to tighten them, as
shown in
Figure 3-14
(2).
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1
Figure 3-14
3 Hardware Maintenance
Figure 3-13
(2).
2
(1).
361
Advertisement
Table of Contents
