HUAWEI USG9500 Series
Hardware Guide
l
l
Procedure
Step 1 Mark both ends of each power cable using a non-permanent marker.
Step 2 Connect the M6 JG2 terminals of the DC power cable to the PEM modules on USG9580.
Connect the M8 OT terminals of the DC power cable to the output terminals on the power
supply device.
Step 3 Use cable ties to bind the cables together at 100 mm intervals, fixing the cables along the
cabling rack from bottom to top.
Issue 03 (2017-12-15)
Cable
NEG cable
RTN cable
DC cable terminals
Terminal
OT bare crimping
terminal (M8)
JG2 double-hole
bare crimping
terminal (M6)
For details, see
Guide to Power Distribution Design of the
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Image
Image
2 Hardware Installation
USG9580.
251