Connecting Optical Fibers - Huawei USG9500 Series Hardware Manual

HUAWEI USG9500 Series
Hardware Guide
l
l

2.2.9 Connecting Optical Fibers

This section describes how to install optical transceivers on the ports and how to connect
them to the peer device ports using optical fibers according to the network plan.
Installing Fiber Spools
Figure 2-20 Installing fiber spools
Cabinet ground
Issue 03 (2017-12-15)
The labels at each end of the cable are correct, clear, neat, and facing the same direction.
The cables and connectors are free of any damage and are connected properly and
securely.
NOTE
Wind excess optical fibers around fiber spools for convenient cable routing and device maintenance.
Determine the locations of the fiber spools based on the device arrangement in the cabinet. Positioning
the fiber spools too close to the device operation area may inhibit board insertion or removal or cabling.
However, positioning the fiber spools too far away from the device may inhibit fiber spool operation.
Install the fiber spool
(right)
M6
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Install the fiber spool
(left)
M6
2 Hardware Installation
258