Table of Contents
Advertisement
HUAWEI USG9500 Series
Hardware Guide
Step 3 Connect one end of a network cable to the electrical transceiver of the USG9580 and the other
end to the Ethernet port of the peer device based on the network plan.
Figure 2-19 Connecting a network cable
1
Step 4 Lay out the network cable along a cabinet and route the cable through the cable hole for the
signal cables at the top (overhead cabling) or bottom (underfloor cabling) of the cabinet.
Step 5 Remove the temporary labels and attach labels (20 mm away from the connectors) at each end
of the network cable.
----End
Follow-up Procedure
Verify the following:
Issue 03 (2017-12-15)
NOTE
The electrical module can be inserted only in odd-numbered interfaces on the 24-port 100/1000Base-X-
SFP flexible interface card.
E8KE-X-101-24XGE-SFP
MPUB
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
LPUF-101
OFL
RUN
Ethernet cable
E8KE-X-LPUF-101
Ethernet interface
of the peer device
2
2 Hardware Installation
257
Advertisement
Table of Contents
