Table of Contents
Advertisement
HUAWEI USG9500 Series
Hardware Guide
Figure A-67 Skew plastic septa
Step 5 Hold the connector with the side facing towards you and check whether you can see the cross-
sections of the core wires. Ensure that the ends of the core wires are in sufficient contact with
the edge of the RJ45 trough and that the soldering edge of a metal contact strip surpasses the
ends of the core wires and is reliably crimped with the core wires. If the RJ45 does not meet
these requirements, replace the connector with a new one.
connector with core wires that are in insufficient contact with the edge of the RJ45 trough.
Figure A-68 Core wires in insufficient contact with the edge of the RJ45 trough
----End
A.2.3.4 Testing the Connection of Assembled Cables
This section describes how to test an assembled Ethernet cable, which ensures that the
connectors and wires at both ends are correctly connected. This section illustrates how to test
a straight-through Ethernet cable.
Context
Huawei provides two types of Ethernet cables: straight-through and crossover cables.
l
Issue 03 (2017-12-15)
Straight-through cables are connected in a one-to-one manner. They are used to connect
network adapters to equipment such as switches or hubs.
connections of core wires in a straight-through cable.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure A-68
shows an unqualified
Table A-30
lists the
A Appendix
463
Advertisement
Table of Contents
