Table of Contents
Advertisement
Working with the Tools Page
Remote Access Permissions
This feature is not currently supported by GrabCAD.
Calibration
The Calibration page allows you to perform a variety of calibration procedures on the printer,
including:
•
Tip Calibration
•
Touchscreen Calibration
To access the Calibration page, press the Calibration button within the Tools page; a screen
similar to the following will be displayed.
Tip Calibration
The printer's calibration status will be displayed within the Tip Calibration row. Calibrated or Not
Calibrated will be displayed depending on the printer's Calibration status.
Pressing anywhere within the Tip Calibration row will open a page allowing you to select from a
variety of tip calibration options.
Figure 59: Remote Access Permissions
This section provides an overview of the Calibration page and its features, but does
not go into detail regarding calibration procedures. See
Adjustments" (page 129)
instructions.
© Copyright 2020 Stratasys. All rights reserved.
for detailed calibration procedure information and
Figure 60: Calibration Page
Figure 61: Tip Calibration
Calibration
"6 Calibration and
Page 81
Advertisement
Table of Contents
