Table of Contents
Advertisement
Customer Replaceable Units
Installing the Oven Light
1. Connect the loose cable connector to the oven light. Orient the cable with the green wire
toward the center of the light. See
2. Tuck the excess cable into the bezel opening and push the oven light into its mounting
position. If necessary, pull the cable from inside the gantry to remove slack.
3. Insert the oven light into the opening above the oven enclosure.
4. Using a 3mm hex wrench, install the retaining bracket and oven light mounting screws (2).
Torque to 21 in-lbs. See
5. From inside the front of the gantry, use a 3mm hex wrench to reinstall the screws (2) that
secure the door box to the oven frame.
6. Reinstall the top gasket pins on both sides of the oven light.
7. Close the oven door.
8. Power ON the printer.
Figure 37 (page
Figure 37: Oven light cable detail
Note green wire
orientation
Figure 36 (page
© Copyright 2020 Stratasys. All rights reserved.
184).
183).
Oven Light
Page 184
Advertisement
Table of Contents
