Table of Contents
Advertisement
Customer Replaceable Units
6. Disconnect the head ribbon cable connectors (2) from the I/O board (J6 and J7). See
Figure
7. Using a 3 mm hex wrench, remove the front ribbon cable bracket mounting screws (3) on
the back of the toggle assembly. Retain the screws for re-installation. See
24.
Figure 24: Head Ribbon Cable Connections
Figure 25: Front Ribbon Cable Bracket Mounting Screw Locations
© Copyright 2020 Stratasys. All rights reserved.
Head Ribbon Cables
Support Head J7
Model Head J6
Figure
25.
Page 171
Advertisement
Table of Contents
