Table of Contents
Advertisement
Customer Replaceable Units
4. Gently remove the touchscreen from the printer. See
Grounding
Cable Nut
Installing the Touchscreen Display
1. Reconnect the grounding cable, touch extender cable and the flat display cable to the back
of the touchscreen display. See
2. Make sure that all cables are connected to the back of the touchscreen display. Tuck any
excess cable behind the display.
3. Use a T8 Torx wrench, to reinstall the touchscreen mounting screws (2). See
Figure 28 (page
Note:
Orient the shiny side of the connector away from the display.
Note:
The flat display cable connector is fragile. Simultaneously push both corners of the
connector straight in, without rocking back and forth.
174).
Note:
Touchscreen calibration should be performed after proper touchscreen operation is
confirmed. See
"Touchscreen Calibration" (page
Caution:
Do not over-tighten screws inside the plastic display housing.
© Copyright 2020 Stratasys. All rights reserved.
Figure 29: Touchscreen removal
Flat Display
Touch Extender
Cable Connector
Cable Connector
Figure 29 (page
Touchscreen Display
Figure 29 (page
175).
175).
82).
Page 175
Advertisement
Table of Contents
