Table of Contents
Advertisement
Monthly Maintenance
the flicker portion of the assembly or whenever bristle clumping (which cannot be removed with
a brush) is apparent within the brush portion of the assembly. The tip wipe assembly is
replaced as a single unit.
To clean the tip wipe assembly and inspect its components:
1. Ensure that the printer is stopped (idle) and is not building.
2. Open the oven door.
3. Remove the model side tip wipe assembly by lifting it upward until it clears its locating pins.
Caution:
Depending on how long the oven has been allowed to cool, components may be hot.
Wear the safety gloves provided in the Welcome Kit to perform all remaining steps.
Figure 11: Tip Wipe Assembly Removal
© Copyright 2020 Stratasys. All rights reserved.
Clean/Inspect Tip Wipe Assemblies
Page 155
Advertisement
Table of Contents
