Table of Contents
Advertisement
Tip Calibration
c. Take the average value of the four measurements. This is the number you will enter for
d. If the value measured in
e. If the value measured in
the Z offset adjustment.
Figure 16: Remove and Measure Support Layer
slice height of 0.010 in. (0.254 mm), the printer is calibrated for the Z axis and an
adjustment is not required. Proceed to
tip's slice height you will need to enter a Z offset adjustment using the Up and Down
buttons within the Manual Tip Calibration page. Each button press equates to one ten
thousandths of an inch.
© Copyright 2020 Stratasys. All rights reserved.
step c
above is within ±0.0005 in. (0.01 mm) of the model tip's
step
4.
step c
above is not within ±0.0005 in. (0.01 mm) of the model
Manual Tip Calibration
Measure support layer
here on all 4 sides
Peel support
layer here
Page 139
Advertisement
Table of Contents
