Customer Replaceable Units
Right and Left Side Louver Panels
Note:
The following procedure describes and depicts replacement of the right side louver
panel only. The left side louver panel replacement procedure is identical to the right
side panel replacement procedure except that the left side panel must be removed for
access.
Required Tools
•
3mm hex wrench
Removing the Louver Panels
1. Power OFF the printer. See Powering Off on page 5-5.
2. Remove the rear panel. See
3. Remove the right side panel. See
4. Using a 3 mm hex wrench, remove the right side louver panel mounting screws (3) that
secure the louver panel to the cover support bracket. See
5. Using a 3 mm hex wrench, remove the right side louver panel mounting screws (2) that
secure the louver panel to the cover buttress. See
6. Gently pull the louver panel away from printer until the formed bracket disengages from the
rear cover standoff fastener. See
7. Remove the louver panel from the printer.
"Removing the Rear Panel" (page
"Removing the Side Panels" (page
Figure 20 (page
Figure 20: Louver Panel Location (Right Side Shown)
© Copyright 2020 Stratasys. All rights reserved.
Right and Left Side Louver Panels
161).
162).
Figure 20 (page
Figure 20 (page
165).
165).
Rear Cover
Standoff Fastener
165).
Page 165