Table of Contents
Advertisement
Warnings and Errors
Model head removed
•
Indicates that the printer lost contact with the model head.
•
Correct condition - ensure that the head is seated correctly within the gantry. If so, remove
the head and then reinstall it. If this does not correct the error, remove the head and install
a new head.
Support head removed
•
Indicates that the printer lost contact with the support head.
•
Correct condition - ensure that the head is seated correctly within the gantry. If so, remove
the head and then reinstall it. If this does not correct the error, remove the head and install
a new head.
File not found
•
Indicates that the printer was unable to locate the job file that was selected for building.
This error pertains to job files loaded via USB flash drive only.
•
Correct condition - ensure that the USB flash drive containing the selected job file is
securely inserted into one of the USB ports within the interface panel (see
Figure 3 (page 20)
the printer's USB ports select the file you'd like to build by loading it to the Job Queue (see
"USB Method" (page
Unknown error
•
An unexpected error occurred in which the printer was unable to map the cause of the error
to a known abort reason.
•
Correct condition - attempt to restart the build, see
instructions. If the error persists, contact Stratasys Customer Support or your regional
Stratasys office (see
for port locations). Once the flash drive is securely inserted into one of
47)).
"Getting Help" (page 192)
The warnings and errors listed below are displayed within the notifications area of the
Head Details page. See
© Copyright 2020 Stratasys. All rights reserved.
"Basic Job Build Tasks" (page 110)
for contact information).
"Viewing Head Details" (page 57)
Build Abort Errors
for details.
Page 202
for
Advertisement
Table of Contents
