Table of Contents
Advertisement
Tip Calibration
5. Completion of the calibration process will be indicated on the screen; press the Finish
button within the header of the page when complete.
6. The main Tip Calibration page will display again. Proceed with the Manual Tip Calibration
as described in
If calibration fails, "Failed to calibrate tip offsets" will be displayed on the screen.
You cannot build a part on the printer until the tips have been calibrated. Ensure
that nothing is blocking the tip or covering the calibration targets and reattempt
the Automatic Tip Calibration. If calibration fails again, perform a Manual Tip
Calibration (see
"Manual Tip Calibration" (page 133)
Figure 6: Automatic Tip Calibration Complete
"Manual Tip Calibration" (page
Figure 7: Automatic Tip Calibration Option
© Copyright 2020 Stratasys. All rights reserved.
Automatic Tip Calibration
for instructions).
133).
Page 132
Advertisement
Table of Contents
