Table of Contents
Advertisement
Modeling Materials
replacement head as the head is nearing its odometer limit. You can continue using a head
which has exceeded its odometer limit, but it is highly recommended that you change the head
as part quality will be unpredictable. The corresponding Head Status Icon will be displayed in
its warning state on the User Interface
or support head assembly is replaced as a single unit (see
instructions). The Head Release Lever locks and unlocks the associated head into or out of its
seated position.
Head Release Lever (one
per head assembly)
Model Head
Assembly
Modeling Materials
Materials Used
The F120 printer can use a variety of model materials, in a range of colors. SR30 Soluble
Release support material is used in conjunction with all model materials. See
for model and support compatibility information.
Table 1 (page 30)
Figure 13: Head Assemblies
Support Head
Assembly
lists the material types available for use with each printer model.
© Copyright 2020 Stratasys. All rights reserved.
(seeTable 6 (page 55)
"Head Replacement" (page 108)
Materials Used
for icon states). The entire model
Table 3 (page 32)
for
Page 29
Advertisement
Table of Contents
