Table of Contents
Advertisement
Basic Setup
#
Item
Needle
Occasionally, you may need to use pliers to aid in the clearing of debris which have
1
Nose Pliers
accumulated on the head and/or tips (see
(extra slim)
Needle
Occasionally, you may need to use pliers to aid in the clearing of debris which have
Nose Pliers
2
accumulated on the head and/or tips (see
1
(7
/
")
8
These are used to cut a material coil box's filament when unloading and removing materials
3 5" Cutter
from the printer. See
Loupe
This tool is included to aid you with performing a Manual Tip Calibration which requires you
4
Magnifier
to view small toolpath relationships. See
Basic Setup
Follow the Site Preparation Guide to ensure that your facility is effectively and safely prepared
for printer installation. Do not proceed with the following sections until the "Unpacking the
Printer" section of the Site Preparation Guide has been completed. When installation is
complete, perform the following setup tasks.
•
Open the top cover and ensure that the orange clip has been removed from the X belt, and
the orange tie wrap has been removed from the X motor. If not, remove the orange clip
and/or orange tie wrap securing these components.
Figure 2: Welcome Kit Contents - Tools
4
Table 2: Key for Figure 2
"Unloading Material" (page
© Copyright 2020 Stratasys. All rights reserved.
1
2
3
Description
"Clean/Inspect Tip Wipe Assemblies" (page
"Clean/Inspect Tip Wipe Assemblies" (page
105).
"Manual Tip Calibration" (page
Welcome Kit Contents
154)).
154)).
133).
Page 8
Advertisement
Table of Contents
