Customer Replaceable Units
6. Carefully remove the camera from the mounting bracket. Retain the mounting bracket. See
Figure
Installing the Oven Door Camera
1. Install the camera to the mounting bracket. See
2. Connect the camera cable to the connector on the back of the camera.
3. Using a 3mm hex wrench, install the mounting screw through the hole in the top of the oven
door to secure the camera assembly. See
Oven Door Latch
Required Tools
•
2.5 mm hex wrench
•
4 mm socket wrench
Removing the Oven Door Latch
1. Power off the printer. See
2. Open the oven door.
3. Using a 2.5 mm hex wrench, remove the inside door panel mounting screws (11). See
Figure
39.
Note:
Do not touch the camera lens. If necessary, wipe the camera lens with a clean
microfiber cloth.
"Powering Off" (page
40.
© Copyright 2020 Stratasys. All rights reserved.
Figure 39: Camera Detail
Figure 39 (page
Figure 38 (page
159).
Oven Door Latch
186).
185).
Page 186