Table of Contents
Advertisement
Basic Job Build Tasks
1. The Abort button within the Build page will be selectable (see
details), press the Abort button.
2. A dialog will be displayed allowing you to confirm or cancel the abort; press the Accept
button within the dialog to confirm the abort.
3. An abort command will be sent to the printer and the confirmation dialog will close.
4. The Z stage will move to its end of travel. Once the Z stage reaches its end of travel the
Build page will refresh and display a confirmation of the aborted build; "CANCELLED" will
be displayed within the Build Status Display (see
Figure 21: Abort Confirmation Dialog
© Copyright 2020 Stratasys. All rights reserved.
"Abort Button" (page 45)
Figure 22 (page
118)).
Aborting a Build
for
Page 117
Advertisement
Table of Contents
