Table of Contents
Advertisement
Working with the Tools Page
Settings
The Settings page allows you to turn a variety of printer settings on/off (including part
placement, standby mode, etc.), configure the language and units the printer/UI is configured
for, and adjust the brightness of the touchscreen display.
To access the Settings page, press the Settings button within the Tools page; a screen similar
to the following will be displayed. Use the scrollbar (along the right side of the page) to scroll up
or down through the list of available options.
Wait for Part
After sending a job file to the printer you would typically need to navigate within the User
Interface in order to select the job from the Queue and start the build. The wait for part setting
will instead allow you to send a job file to the printer which will then immediately start building
once received by the printer.
Pressing anywhere within the row will open the Wait For Part page. Opening this page will
automatically put the printer into a state where it will wait to receive a job file to build
immediately. After putting the printer into this state, you must send the processed job file to the
Figure 36: Settings Page
Figure 37: Wait for Part
© Copyright 2020 Stratasys. All rights reserved.
Settings
Page 72
Advertisement
Table of Contents
