Table of Contents
Advertisement
Head Replacement
1. Unload material from the head that will be replaced (see
for instructions).
2. With the printer powered ON, open the top cover (see
3. Depress the release tab and unclip the head ribbon cable for the head that will be replaced.
4. Disconnect the material tube for the head that will be replaced.
5. Unlock the head release lever for the head that will be replaced.
Material
Tube
Head
Ribbon
Cable
Head
Release
Lever
Replacing a head while the printer is powered ON will ensure that an Automatic
Tip Calibration is performed after the replacement process is compete.
Power is automatically removed from the head and all motors when the top cover
is opened.
Figure 16: Head Connections
© Copyright 2020 Stratasys. All rights reserved.
Replacing a Head
"Unloading Material" (page 105)
Figure 1 (page
18)).
Page 109
Advertisement
Table of Contents
