Table of Contents
Advertisement
Basic Job Build Tasks
•
The Build button will display a green checkmark icon indicating that the build completed
successfully.
Removing a Part from the Printer
To remove a part from the printer:
1. Open the oven door.
2. Push down on the substrate ejection handle to release the substrate.
3. Remove the substrate from the platen.
4. Carefully remove the part from the substrate.
If the build was terminated abnormally, a warning indicator will be displayed on the
screen. See
"Build Abort Errors" (page 201)
and resolution instructions.
Figure 23: Print Successful Dialog
Warning: Hot Surface Hazard
Wear proper safety equipment when handling items inside the oven as surfaces
within the oven can be very hot.
Caution:
Do not attempt to remove a part from the substrate while the substrate is on the
platen. Damage to the platen or platen level may occur.
© Copyright 2020 Stratasys. All rights reserved.
After a Build is Complete
for a list of abort related warnings/errors
Page 119
Advertisement
Table of Contents
