Table of Contents
Advertisement
Working with the Tools Page
Working with the Tools Page
The options within the Tools page are organized into 6 categories: Settings, Calibration,
Maintenance, Network, Power, and Light. The Display Area of the Tools page contains a button
corresponding to each of these categories. With the exception of the Light button, pressing the
button corresponding to each of these categories will open an individual page containing
printer information that can be viewed as well as printer settings and preferences which can be
configured for that particular category. After selecting any of the buttons within the Tools page a
"Back" button will be displayed within the heading of the page; press this button to return to the
main Tools page.
Within this page you can turn a variety of printer settings on/off (including part placement,
standby mode, etc.), select your printer's address type (dynamic, static, or Wi-Fi), adjust the
brightness of the touchscreen display and turn the printer or the oven light on/off. As a part of
its initial installation and setup (performed by your authorized service representative) your
printer's network settings will be configured within this page (as described within
the Network" (page
access this page in order to adjust printer preferences.
To access the Tools page, press the Tools button within the Navigation Menu; a screen similar
to the one in
11)). Once those settings are configured you may need to occasionally
Figure 34
will be displayed.
© Copyright 2020 Stratasys. All rights reserved.
Figure 34: Tools Page
Material Load Controls
"Configuring
Page 69
Advertisement
Table of Contents
